Large Lcd Display Analog VICTOR Digital Multimeter 1000V 10A 200MΩ

Large Lcd Display Analog VICTOR Digital Multimeter 1000V 10A 200MΩ

VC3021 Analog Multimeter Large Lcd Display 1000V 10A 200MΩ

SPECIFICATIONS

General specification

Items Specification

Drop shock proof: Taut-band structure is adopted in the meter section. The meter section is designed to withstand shock.

Circuit protection: The circuit is protected by fuse even when voltage of up to AC 230V is impressed on each range for 5 seconds.

Internal battery: R6 (IEC) or UM-3 1.5V×2

Internal fuse: 0.5A/250V 5.2mm dia ×20mm

Standard calibration temp

And humidity range.: 23±2℃ 45-75% RH

Operating temperature and

humidity range.: 0-40℃, 80%RH max. No condensation

Withstand voltage: 3KV AC(1 min) between input terminal and case

Dimensions and weight: 150×100×38mm approx. 300g

Accessories: Instruction manual Test leads.

WARNING

To ensure that the meter is used safely, follow all safety and operating instructions

1. Never use meter on the electric circuit that exceed 3KV.
2. Pay special attention when measuring the voltage of AC30 Vrms or DC 60V or more to avoid injury.

3. Never apply an input signals exceeding the maximum rating input value .

4. Never use meter for measuring the line connected with equipment (i.e.motors) that generates induced or surge voltage since it may exceed the maximum allowable voltage.

5. Never use meter if the meter or test leads are damaged or broken.

6. Never use uncased meter.

7. Be sure to use a fuse of the specified rating or type. Never use a substitute of the fuse or never made a short circuit of the fuse.

8. Always keep your fingers behind the finger guards on the probe when making measurements.

9. Be sure to disconnect the test pins from the circuit when changing the function or range.

10. Before starting measurement, make sure that the function and range are properly set in accordance with the measurement.

11. Never use meter with wet hands or in a damp environment.

1. 2. Never use test leads other than the specified test leads.
1. 3. Never open tester case except when replacing batteries or fuses. Do not attempt any alteration of original specifications.

14. To ensure safety and maintain accuracy, calibrate and check the meter at least once a year.