XI'AN BEICHENG ELECTRONICS CO.,LTD
The Best Quality, The Best Service!
Add to Cart
VICTOR 140 Clamp Leaker Function Measurement Of AC Leakage Current, AC Current And On-Line AC Current Four Bits LCD Display
Introduction
Technical specifications
| Function | Measurement of AC leakage current, AC current and on-line AC current | |
| Power | DC3V Button-type battery LR-44×2 or SR-44×2 | |
| Test Mode | Clip-on CT,integral mode | |
| Display Mode | Four Bits LCD display | |
| Dimension |
Width × Height× Thickness: 64mm×160mm×23mm |
|
| LCD Dimension | 35mm×21.5mm；display domain:32mm×15mm | |
| Clamp Mouth | φ40mm | |
| Sampling Rate | about 2 times/s | |
| Range | 0.00mA～300.0A(50/60Hz) | |
| Resolution |
0.01mA |
Technical specifications(Continuous form)
| Measuring range | 30mA/300mA,30A/300A,second-range manual switch,Automatic switch in all ranges | |
|
Measurement accuracy (below 23℃±1℃, 70%RH) |
0.00mA～9.99mA: ±1.2%±5dgt | |
| 10.0mA～300.0mA: ±1.5%±5dgt | ||
| 0.00A～9.99A: ±1.2%±5dgt | ||
| 10.0A～99.9A: ±1.5%±5dgt | ||
| 100.0A～199.9A: ±2%±5dgt | ||
| 200.0A～300.0A: ±4%±5dgt | ||
| Line voltage | Line test under AC600V | |
| Data Storage | 60 groups, “FU” symbol flickering means storage is full | |
| Peak Holding | Peak value capture and holding function, pressHOLD button continually to show peak value in the course of testing. | |
| Data Holding | Data holding function:displayed by “DH” symbol | |
| Overflow display |
Outrange overflow display:displayed by “OL” symbol |
Technical specifications(Continuous form)
| Automatic shutdown | After starting up the leaker for 5 minutes, it will shut down automatically to reduce battery consumption. |
| Battery voltage | When battery voltage reduced to 2.5V～2.7V, battery low voltage symbol will filker to remind replacing battery; at this time, measurement accuracy will decrease. |
| Leaker Quality | About 120g(with battery) |
| Rating Power | about 5mW |
| Working temperature and humidity | -0℃～40℃；below 80%rh |
| Storage temperature and humidity | -10℃～60℃；below 70%rh |
| Insulation strength | AC2kV/rms (between core and box) |
| Applicable safety rules | IEC1010-1,IEC1010-2-032,pollution, etc 2,CAT Ⅲ(600V) |